Ask Experts Questions for FREE Help !
Ask
    Domeclimber's Avatar
    Domeclimber Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 9, 2012, 11:28 AM
    Pressure switch replacement
    Can I use a 30/50 switch to replace the 20/40 in current use?
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #2

    Jan 9, 2012, 03:20 PM
    Is this on your well or what?
    jlisenbe's Avatar
    jlisenbe Posts: 5,020, Reputation: 157
    Uber Member
    		  
    #3

    Jan 9, 2012, 05:30 PM
    Good question. If it is on a well, you can do it and will probably like the results. You can also simply adjust up your current 20/40 to at least get close to the 30/50.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

My gas furnace is not getting vacuum pressure for the pressure switch. [ 1 Answers ]

All the hoses were replaced as well as the pressure switch it self. I can jump it and it fires right up. It's a Heil model. The pilot light lights automatic. If you take the hose off that goes to the pressure switch and suck on it, it switches and the pilot light lights off. I don't know much...

York residential furnace pressure switch problem code stuck switch [ 1 Answers ]

I have a york furnace P2MD12H06401A after 1 hour it shuts down and gives a 2 flash error for a stuck pressure switch. The switch is new can it be wired wrong? The old one had 2 white wires piggy back and 1 blue wire. The new switch has 3 separate terminals

Pump pressure switch does not turn on with low pressure [ 0 Answers ]

I lost water in my home overnight. The pressure gage reads about 8 PSI. If I use the lever on the pressure switch to close the contacts, nothing happens. Actually, the pump controller box, makes a buzzing sound for a couple of seconds, but that's it. Does anyone have any thoughts? I don't...

Armstrong Ultra SX 80 Replacement Pressure Switch [ 2 Answers ]

I need to replace my pressure switch made by TRIDELTA. I believe it is part number PPS10090-2615. It also has the following numbers: 046317/0014/B and 44819-002. Does anyone know what the specs are for this pressure swtich? Is there a less expensive option for replacement? Any feedback...

Deep well, pressure tank/switch not building pressure [ 13 Answers ]

The only way I have water pressure is to leave the power on! I have replaced the 5 gallon pressure tank (28psi when void of water)/fittings/pressure gauge and tried 3 new 30/50 pressure switches and the problem remains the same. With the power off, the pressure drops to 0 (not 30). When I...

View more questions Search