 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
I have a 2006 Ski-Doo Summit 800 HO snowmobile and I get no spark?
It was idling when it made a backfire noise and died. I no longer get any spark when I try to start it. The kill switch on the handlebars works fine. The tether switch has three wires coming from it and only 2 are connected when the cap is on the switch. The wires are black, green, and white. The black and green are the 2 that connect when I put the cap on. The white wire does not connect to either of the other wire with the cap on or off. I do not have a wiring diagram for troubleshooting.
|
||||
Check out some similar questions!
I have an old 1991 Arctic Cat Jag snowmobile. It was not running for a few years and the mice took over. Anyway, I cleaned out the entire fuel system and carburetor and managed to get it running again. It seemed to be running well. I took it to a lake for a ride and drove it about 1/2 mile or more...
I have a snowmobile with one serial number on the motor... it is a 1997 ski doo... police are claiming it was stolen but there is no claims on it being stolen through the police department... what can I do? Do they have the right to keep it in their possession knowing that it is 13 years old and no...
Just got a free Toro lawn mower and it won't start. Tank was empty so I put new gas in. Pushed primer bulb as instructed and gas squirted out of little red tube inside carb. I had the air filter off so I could see this happening. Sprayed in some starting fluid and still not a pop. Removed spark...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
