Ask Experts Questions for FREE Help !
Ask
    paco955's Avatar
    paco955 Posts: 4, Reputation: 1
    New Member
    		  
    #1

    Jan 3, 2012, 06:05 PM
    1995 GMC Sierra pick up
    1995 GMC Sierra pick up 5.0 l motor. Motor cranks but does not turn on. I checked all fuses and fuel pump relay and I disconneted the fuel line and opened the switch and fuel came through.and still doesn't start. I poured gasoline in throttle body and it turned on but turned off after gas finished. I tried different computer modules but this did not help. I observed that the fuel injectors don't open and also the fuel pump current is not optimal. What else do you think I should do?
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #2

    Jan 3, 2012, 06:28 PM
    Replace the Ignition Control Module (ICM), located inside the distributor.
    paco955's Avatar
    paco955 Posts: 4, Reputation: 1
    New Member
    		  
    #3

    Jan 4, 2012, 06:34 PM
    I tried to replace the ICM inside the distributer but this did not help. Also the fuse for the fuel pump relay does not have power. Any other suggestions?
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #4

    Jan 4, 2012, 06:38 PM
    Check all under hood and under dash fuses with a test light or multimeter. Turn the ignition switch to ON and check for power through both test points on every fuse--red to fuse, black to ground. On trucks, in Texas, I often have to remove and clean the contacts on under hood fuses and fuel pump relays--corrosion and dirt build-up badly.

    If you have an inertia cutoff switch to the fuel pump, reset it. These are most common on Fords, however.

    Check the ignition switch for wear, pitting, or melting, if the problem persists. Disconnect the negative. Battery cable first.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

2001 GMC Sierra -- headlights won't work [ 3 Answers ]

We have a 2001 GMC Sierra pick-up. The headlights will not work. It's been hooked up to a diagnostic computer by a mechanic and they can't find anything wrong with it. The computer says the lights are on and they're not. Fuses have been checked and changed, light bulbs have been replaced, the...

99 GMC Sierra - starting problems [ 3 Answers ]

My truck is about to hit 200K miles and it runs and looks like new, except it has trouble starting. Every morning, or the first time that day, I go get in my truck it starts right up. But if it has been running recently it takes at least 5 to 10 sec of running the starter before it will idle. In...

77 gmc sierra ignition [ 3 Answers ]

After pulling steering column off, there is a lock ring with split that is stopping me from removing metal plate that I have to remove to get to the ignition. Is there a certain tool that I have to have to remove that. Tried a screw driver but it won't work.

My 1991 GMC Sierra is overheating [ 1 Answers ]

I had my engine taken out of my 1991 gmc sierra to get the rear main seal resealed, and the intake manifold resealed. After Putting the engine back in, it overheated. So I replaced the thermostat, radiator, and water pump, but it still overheat. If I take out the thermostat it does not overheat,...

96 GMC Sierra no crank [ 3 Answers ]

Today the truck was starting slow, sounding like it was turning over under water, but then starting and running fine. This evening I went to start it and nothing. No turn over no cranking, nothing. Replaced the battery and still nothing. Checked all fuses and fuel pump, nothing. Checked the...

View more questions Search