Ask Experts Questions for FREE Help !
Ask
    harley2011's Avatar
    harley2011 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 28, 2011, 04:32 PM
    Furnace blower
    I have a Intertherm thermastat in my mobile home that stops turning the blower on from time to time in the auto position, if I turn it to on position it works the blower fine, after that I can switch back to auto and it works for a while
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
    		  
    #2

    Dec 28, 2011, 04:53 PM
    Hi harley. The thermostat does not directly control the fan when in the auto position. In the auto position, the stat only sends a call for heat to the furnace, which then starts the heat cycle and the blower is kicked on through a relay in the furnace. So it sounds like your fan control in the furnace itself may be fualty. I you have a control board vs separate controls and relays, then you may need a complete new control board. However, since the fan is working well when the stat is in the on position, you can just let the fan run continuously, as long as the heat is working corectly when the stat calls for heat. Good luck, and please let me know what you find.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Carrier furnace: limit switch fault furnace has ignition but blower will not come on? [ 2 Answers ]

Board says it is a limit switch fault Furace goes into pre ignition, fan comes on and sometimes even the main burner ignites, but the blower will not come on... is this the blower motor or could this be a switch somewhere?

Bryant furnace showing code 12-blower on after power up. Furnace won't start. Why? [ 0 Answers ]

Blower motor on all the time. No heat from furnace. Why?

Tran furnace / air main blower on furnace will not run. But the a/c unit runs [ 0 Answers ]

Main blower on furnace, is not running, when thermostat calls for cooling the out side unit runs. The main blower on the furnace in not

I have a trane eletric ignition heater and blower furnace is heating up but no blower [ 1 Answers ]

My thermostat is a white /rodgers module this clicks to start but no air blowing from the furnace in the attic which is a trane model and the same with cold air the thermostat clicks the ducane model outside whirs but no cols air.

Furnace Blower Motor Runs Constantly & Furnace or AC Won't Run [ 2 Answers ]

I have an Armstrong forced air (induced draft) natural gas furnace with central AC (made around 1990 -- Model: EG6H80DC14-1, Serial: A18315MNA). I had a problem at the end of the heating season where the blower motor would run continuously (even when the thermostat is turned to "off"). I thought...

View more questions Search