 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
Check out some similar questions!
My furnace is 5 years. Every time it calls for heat it fires up just fine but then after 3 sec. the gas turns off, it repeats this cycle until it locks out the system. I have reset the system, checked all the wiring for loose connections but cannot get it to run. Please help me.
Kenmore elite gas dryer only stays lit for 10 seconds, goes out for 1 to 2 minutes then does this again
Have an amana high efficiency furnace that has the electronic iginition and it will ignite and stay burning for about 30 seconds than turn stop.
The older sears furnace here, has a pilot light that lights But goes out, as soon as the pressure on the pilot button is released. Now two times it did stay lit and then soon went out. If the orifice needs cleaning are there diagrams of where that is or how to do that? Thanks
Today I cleaned out the space beneath the water heater flue connection in the wall, supposedly this area is for that purpose; to clean out the flue. You would not believe what the last tenant jammed in there... 2 bed sheets! OK, well I cleaned that out, plus a half of a bucket of dirt. We replaced...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
