Ask Experts Questions for FREE Help !
Ask
    lesrmore's Avatar
    lesrmore Posts: 2, Reputation: 1
    New Member
     
    #1

    Dec 23, 2011, 03:06 PM
    Blower works but ignitor won't glow
    Changed the ignitor and thermostat on a goodman furnace. The fuse is good and the indicator light says that everything is normal. Should I start with the control board first?
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
     
    #2

    Dec 23, 2011, 05:50 PM
    Well seems like you have already done 2 things first
    You don`t say if the inducer motor was working, (this is the much smaller motor that pulls out excessive gas and blows the exhast out the vent pipe), this has to be the first thing that happens before the igniter can start glowing

    Here is the 1-2-3-4 order of what should happen

    1st-- the tstat calls for heat
    2nd-- the inducer fan starts up
    3rd-- the igniter fires up (glows)
    4th-- the gas valve opens to let gas exscape to the burners
    5th -- the burners fire up (caused by the gas connecting with the glowing igniter)
    6th-- within 30 to 60 seconds the bigger main blower will come on and blow nice warm air into your living area
    Now each step has to happen before the next step will happen
    Check it out and tell us what is not working


Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Furnace ignitor doesn't glow [ 0 Answers ]

When the stat calls for heat the blower runs for a while then shuts down, then the inducer runs for a while then shuts down, at no time does the ignitor glow. I put a meter on the wires going to the ignitor and found no power during the start up sequence. Also error code 32 flashes.

Ignitor works but not getting any power now what [ 1 Answers ]

So tested ingniter and works just fine after reading another post I checked for voltage to the igniter and there is none so now I don't know what to do - the other question was fixed at this point- Is it a fuse? The board? Help! No HEAT is cold

York Diamond 80 Ignitor works abd blower runs but does not heat up house [ 3 Answers ]

Our basement unit York Diamond 80 runs and run with the ignitor working and the blower running but does not heat up the first floor. The unit in the attic heats the first floor fine. The exhaust vent seems to be extremely hot. Is it possible the motor that exhausts the cabon monoxide from the gas...

Ignitor works, just not in the furnace [ 17 Answers ]

I posted a question before about how my ignitor kept going out. Well after replacing the ignitor again last night and the furnace not working again this morning, we tested one of the old ignitors. I guess it hasn't been the ignitor after all because when one of the old ones was plugged into 120...

No Ignitor Glow [ 8 Answers ]

Not sure the brand.. When I have the thermostat call for heat the vent blower and the blower both come on and there is no glow.. I have tested and bypassed the limit switches and that doesn't fix the problem. Now the diagnoses light flashes 4 times which is supposed to mean that there is an open...


View more questions Search