Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Installing vinyl siding onto overlapped T1-11
[ 6 Answers ]
This spring I plan on installing vinyl siding over my existing T1-11. I do have a few questions due to the way the T1-11 was installed. I'll try my best to explain. I have a two story home. The top sheet of T1-11 overlaps the bottom sheet probably by a couple inches. So it is not a true "flat"...
Installing sheet vinyl flooring
[ 2 Answers ]
Can you put a foam pad under the vinyl floor?
Vinyl wainscoting installation
[ 1 Answers ]
We have purchased a prefinished vinyl wainscoting kit and are now wondering the best way to install it. The instructions say we can nail it in or glue it. We are concerned that patching nail holes will leave marks in the finish and gluing will damage the drywall if we ever decide to remove the...
Correct way of installing a vinyl shower pan
[ 12 Answers ]
What is the proper way to install a new vinyl shower pan? Is it wrong to screw through the pan and cement into the marine board on the wall side? Won't that cause leaks eventually? I read that nothing should be screwed in below 8" of the bottom of the wall. And is there a special screw that needs...
Installing tile over vinyl flooring?
[ 3 Answers ]
I have installed ceramic, porcelain, and natural stone tile previously. In those cases, I also installed the underlayment, using 3/4" plywood (glued and screwed) and then 1/4" cement board (thin-set mortar and screwed). I am now considering another tiling project in our bathroom. I was... View more questions Search
|