Ask Experts Questions for FREE Help !
Ask
    LarryDenton's Avatar
    LarryDenton Posts: 1, Reputation: 1
    New Member
     
    #1

    Dec 15, 2011, 02:49 PM
    Carrier code 33
    I replaced circuit board blower motor capacitor. Now the blower stay on and give code 33. And the furnace will not ignite. A new filter is installed.

Check out some similar questions!

Carrier furnace with a red flash code of 2 short and 1 long code [ 2 Answers ]

I have a Carrier and the furnace and the heat will not come on. The fan does come on but the burners will not ignite. I get a red flash code of 2 short and one short. I have the same thermostat upstairs and I switched them and the same result. The upstairs works fine with both thermostats. I have a...

Carrier Code #34 - intermittent [ 4 Answers ]

Hi: I have a Carrier 800 VS 58CVX070. Installed in 2003 A few weeks back we had a power outage and since then the Furnace has been a little funky. The main problem is that the trouble is intermittent. I keep getting status #34. Usually it happens late at night so, everything seems fine all...

My carrier furnace LED light is flashing a code. How do I tell what code it is? [ 1 Answers ]

The error code is flashing and I know certain lengths, long and short indicate a code but how do I tell which one it is?

Carrier code 45 [ 1 Answers ]

Carrier furnace flashing a code 45 says replace control. Which control? Control board, thermostat or what?

Carrier 9200 code 41 [ 2 Answers ]

I have a carrier 9200 furnace flashing code 41 it will ignite and flame but cuts off after blowing for a couple of minutes. Is the moter a DIY project I see the motor cost about $500 online. Thanks a bunch


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.