Ask Experts Questions for FREE Help !
Ask
    jthielke's Avatar
    jthielke Posts: 1, Reputation: 1
    New Member
     
    #1

    Nov 18, 2011, 01:01 PM
    Very old Goodman Model # HCC100N54R forced air gas heater
    There are three reset sensors on this unit. One on each side of the heat exchanger and one in the heat exhaust flue. The unit kicks off after about 5 minutes operating. I have to reset the sensor to get it to come on again for it to do it again. I have cleaned the sensor itself with sand paper. Filters are all clean and air flow seems to be good. I would suspect that the sensors need replacing. I need to find a source for purchasing.

Check out some similar questions!

Honeywell model # T8MPN100F14A1 forced (gas) air [ 1 Answers ]

My furnace will not continue to work once the desired temp is reached. Normally when the temp drops below the programed temp the unit powers on and sends heat through out my home. Problem I'm having is you can hear the pilot ignitor clicking but it does not glow to light the pilot light,after a...

Goodman GDS8090 gas forced air furnace [ 3 Answers ]

I have a question regard my goodman furnace on the "blink" (no pun intended). After discovering it to not be working properly I removed the front panel to find the blinking red light. It is blinking three times. I reviewed the troubleshooting guide to find 4 possibilities. I removed what I...

Heater gas forced air [ 1 Answers ]

I have a combo heat and cooling system the problem is with the heat the unit cycles glow light comes on the furnace firers up and then shuts down I have to reset the system two maybe three times what causes this seem like every night I have to go through this what can it be

Problem gas forced air heater [ 3 Answers ]

When I turn thermostat on it clicks, but no heat. My son turned just the fan on it works, he opened door to heater said the pilot light is ignited and first time the burners came on. They then went out and then wouldn't come back on.

3 yr old Goodman Gas Forced Air Furnace problems [ 10 Answers ]

If thermostat is set to 70-90 degrees the furnace burner and blower will run constantly and the temp never gets above 68 degrees in the house. I have a Lux programmable thermostat and was thinking of replacing it with a Honeywell. I have a new filter. Any ideas? The weather has been in the...


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.