 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Carrier/BDP Gas Furnace Model #397HAW048120
My mother who is on a very fixed income has Carrier/BDP Gas furnace #397HAW048120, installed around 1983 that won't come on. When I cycle the power switch I hear the relay on the control board click. I pulled off the covers and the cover off the control panel. When I cycle the power On and Off the first relay on the left of the control board will flash when power is applied. Nothing else will happen. The fan inducer fan motor will not come on. Where should I look next?
|
||||
Check out some similar questions!
I have tried almost everything in my arsenal to try and diagnose the problem. First off I have a Carrier Gas Furnace that is almost 7 years old. Model 58MCA-80 (See attached photo for more information), with pressure switch #HK06NB123. Intermittently I get a Red Flashing Code #31 when the unit...
First, the gas valve on the pipe is on, I set the thermostat to supply heat, the furnace goes through the start up cycle normally, blower starts, inducer starts, pressure switch closes, ignitor glows but the gas valve doesn't open. Checked the limit switches, all show 26 volts, but no voltage at...
The blower fan won't shut off unless you push the door switch. Blows cold air, fan never shuts off Any Ideas? Should I replace the high limit switch and circuit board? I have found the parts online and also found a Digital Circuit Board upgrade raising the cost from $70.00 to $148.00. Is it...
Guys sorry for my ignorance its cold! Carrier 58ES125-2D or 5BES125-2d Pilot comes on for approximately 2-3 seconds clicks shuts off and retries over and over any ideas, may even click as it goes on? Thanks I cleaned it with steel wool and light sand paper, same thing pilot starts and goes out...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
