 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Gas furnace fan will not come on in auto...
I have a Nordyne furnace the thermostat will not allow my fan to turn on when it heats up.. I have to manually turn the fan on... Could I have done something to the thermostat? I too can not afford a techie to help... Please any advice?
|
||||
|
||||
|
I have to manually turn the fan on...
When you say this are you spinning the blade to give it a boost to start? Or are you setting the tstat to fan instead of auto ? To get it to run If it's the 1st ,spinning with your hand you may need to replace the capicitor which is very cheap with an exact match of the old one |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
The furnace comes on and heats up, the fan comes on for about 30 seconds then shuts off. The fan will run when I switch to manual on the thermostat.
My gas furnace (Ultra SX90 Armstrong)will not work when my thermostat (Thermostat – Honeywell - RTH230B) is switched to "auto". When the thermostat is switched to "on" it runs fine (or, at least, it did until I altered the programming on the thermostat this morning-- now nothing seems to work). ...
Is it better to leave the fan set to auto or always on, especially during extreme cold conditions when furnace is kicking on much more often? The furnace is 3 years old.
The auto fan works fine when set to air conditioner, however, it does not work when put to heat (furnace) side. The furnace works because when you put it to fan only it will blow out heat. Just won't blow out heat when put to auto and using the furnace. Works fine with air conditioner Can you...
I have a Carrier gas-pack Heating/Airconditioning system (about 12 years old). A few weeks ago I noticed the heating cycle was not working. I ran some checks to determine the cause and discovered that the main circulation fan was never coming on when the fan was set to the "Auto" position. The gas...
View more questions Search
|
