Ask Experts Questions for FREE Help !
Ask
    stanmcc's Avatar
    stanmcc Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 5, 2011, 07:46 AM
    12.5 briggs lack of consistent spark
    12.5 hp briggs does not have consistent spark to the plugs, anyone know what would cause this?
    DG's Avatar
    DG Posts: 1,375, Reputation: 109
    Ultra Member
    		  
    #2

    Nov 5, 2011, 07:53 AM
    Could be the coil / amuture .
    Or key switch .
    Ground going to the engine .
    If its on a tractor could be safety switch.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Dumped over a lack of 'spark' - advice required and opinions welcome [ 5 Answers ]

Hello, I'm a 26 year old male who until 6 weeks ago was in a relationship with a 25 year old female. We had been together for 2 years and before then had been very good friends for 18 months, in fact I knew from a very early stage of our friendship that she was attacted to me. I was dumped on...

Briggs 14.5 hp ohv - No spark to spark plug [ 1 Answers ]

Was mowing tall grass when it died. At first there was a small spark at the plug but now there is none. Had been having to use pickup to jump start the Huskee 38" riding mower. Where can I find a schematic for this engine. Model 287707 Type 1224-E1 Code 000531ZD

12.5 briggs and s that lost spark magnito replaced and no spark [ 3 Answers ]

I have a Deutz-Allis 613 lawn tractor with a B/S 12.5 horizontal engine. When I got it. The engine would run fine unless it was under a load... if the choke was pulled out half way the engine wouldn't stall. I replaced the drive belt and then the mower belt sharpened the blades and the tractor...

Muffler turns red hot, and lack of power 18.5 briggs [ 2 Answers ]

I have a craftsman 18.5 intek plus model 31p777/ type 0348e1/code 010406ze. It had a bent rod when i got it and found the valve was stuck solid. I reused the valves and ground and seated them and set intake at .004 and exhaust at .009, i also replaced the key at flywheel.it starts but has low power...

View more questions Search