 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Carrier 58es125
Pilot lights, burner does not kick in. "Proven Pilot Control" LH33CM601 has two wires that go to the pilot area. I am guessing one is to ignite the pilot and the other is flame sensor. How does a single wire flame sensor work? Any help would be appreciated.
|
||||
Check out some similar questions!
I am working as a SAP PP Core user. Now tell me further education so I build my carrier
Which is a better system, Carrier Comfort 14, Puron, 3.5 ton, single stage, 16 SEER, air conditioning and heating system, condenser model 24ACB442A003 to new refrigerant lines using Carrier evaporator coil model CNPVP6024ATA, ON TOP OF A CARRIER iNFINITY VARIABLE SPEED GAS FURNACE MODEL...
Carrier 58ES125-2D or 5BES125-2Pilot comes on for approximately 2-3 d Seconds clicks shuts off and retries over and over any ideas, may even click as it goes on? Thanks I replaced the flame sensor same thing pilot starts and goes out 2-3 seconds. What's next the proven pilot control? Thanks...
Guys sorry for my ignorance its cold! Carrier 58ES125-2D or 5BES125-2d Pilot comes on for approximately 2-3 seconds clicks shuts off and retries over and over any ideas, may even click as it goes on? Thanks I cleaned it with steel wool and light sand paper, same thing pilot starts and goes out...
I have had same problem with Carrier furnace - don't know model # at this point. After about 20 hours of working, furnace won't work unless blower switch is shut off/on. Or, open door/close it. I was informed by similar help site to replace the surfface heat ignitor, which can break as often as a...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
