 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Led light flashing twice.
I have a nordyne furnace in a mobile home and when I turn it on, the LED light flashes twice. Which says the pressure switch is open, I have checked the vent going out through the roof and did not see anything plugging it. The fan does not even start when turned on. All I can hear is one click on the switch board and then nothing. Any suggestions.
|
||||
Check out some similar questions!
The error code is flashing and I know certain lengths, long and short indicate a code but how do I tell which one it is?
Have a 3ton Payne Gas frunace... the Ignitor glows and the Gas Valve opens,the burners turn on,but after about a minute,the flame goes out and the Induced Draft motor shuts off.Only the blower stays running... the red led light keeps flashing... what is wrong? I replaced the ignitor,but the problem...
I installed a CESO 110057-02 board on a Bryant 373LAV product and the trouble code reads fast flashing for reversed polarity or twinning problem. Reversing the polarity had no effect. There is no twin. 24 VAC transformer replaced. Blower only comes on. Any help appreciated, Vern
My furnace does not blow out any heat but only cold air blows out.. trane XB90 and the diagnostic LED light is flashing 4 times... please help we are cold.. the code for 4 times flahinf light says open limit device.
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
