 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Is there a way to check the burner sequencer switch on a coleman oil furnace
Sometimes the furnace starts when the stat calls, sometimes several minutes later, other times not at all. If I shut the power switch off then back on, while calling, it will start. I replaced the primary control, assuming it was the problem.
|
||||
Check out some similar questions!
Coleman evcon furnace, glow light glows but the burner doesn't light.
I was curious as to if anyone can tell me anything about the above product(s). Reason being is because I had no choice in which new high-efficiency furnace would be installed. I have a home warranty through AHS (which is horrible) and this is the product that was installed. Is Bryant as good as...
My Interthrem electric furnace will not run in automatic;I've changed the sequencer per suggestions,but to no avail what can I do?
I have the pilot on, electrical on, the fan works, the filters are clean, the thermostat is working properly, yet the burner will not ignite. The furnace worked just fine last night.:confused:
The problem goes like this. Thermostat calls for heat, burner starts and runs for a minute or so and shuts off. After burner shuts off, the blower starts and the burner starts again until the thermostat reaches temp and the burner shuts off blower contiues to run until the low temp limit is...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
