 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Tempstar 7000 Furnace Not Lighting
I have a Tempstar Furnace that is not lighting. When I turn the thermostat on the exhaust blower turns on like normal. Then the igniter lights the pilot. Once the ignitor stops the pilot stays lit for about a second and a half. At this point there is a sound that sounds like a switch being flipped, and then the pilot light goes out. The heating elements never light.
|
||||
Check out some similar questions!
My Heil 7000 furnace, installed new in 1993, is leaving a wet spot on the floor just below the lower right panel edge. When I slide my finger along this lower right edge, there is accumulated water, which is dripping ever so slowly, causing the wet spot. What might be the cause of this never before...
On initial start up on my Heil 7000 furnace it is making one heck of a noise until the blower comes on at which time everything is normal. Heater is working perfectly at that point. Do you have any ideas?
Furnace Info: -Upflow Condensing Gas Furnace is a Heil 7000 (model# NUGK075DG09) -Electric spark or host surface ignitor ( I think it's spark) -Installed Oct. '96 (when we built the house) -90% efficiency -wall thermostat is honeywell programmable. Don't know model but was also purchased in...
Furnace is not staying lit, it a temstar LP forced air # nulk100dh06. If I turn the thermostat up after it has just shut down, the ignighter lights the burners they run for a few seconds, the blowerkicks on and as soon as it does the buners shut down. I shorted out the thermostat, and get the same...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
