Ask Experts Questions for FREE Help !
Ask
    New2zone's Avatar
    New2zone Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Feb 6, 2007, 12:11 PM
    No heat in 2nd fl room
    I have a 2 zone system and the master bed room on 2nd floor is barely heating. I have the themostate in the master room set to 68 degrees and the fan set to auto. There is also a return air vent in room. There are 2 heat vent on ceiling. When I put my hand under it, it is warm but the whole room seems to be not getting enough coming through.
    The rest of the second floor is well heated as long as doors are closed and the 1st floor is no problem ( the temp is set to 68 degrees and fan is also set to auto. We had it checked and they played with the dampers and still not enough heat. Someone even suggested turning up the temp to pass 70+ but if I do that, my heating bill will be into the $500+ . What could the problem be? Any suggestions...

    Thank you.
    rickdb1's Avatar
    rickdb1 Posts: 185, Reputation: 15
    Junior Member
    		  
    #2

    Feb 6, 2007, 04:17 PM
    If it's lack of airflow, then the first place to start is the filter to make sure it is clean...
    New2zone's Avatar
    New2zone Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Feb 7, 2007, 08:01 AM
    Quote Originally Posted by rickdb1
    If it's lack of airflow, then the first place to start is the filter to make sure it is clean...

    I just replace the filter a few weeks ago but will take another look at it... The lack of airflow is only in the master bed room.. the other parts of the house... 1st fl and 2nd fl rooms and hallways of heated...
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

NO HEAT! Janitrol heat pump and AC system. Changing to Lux Thermostat. Wiring issue. [ 11 Answers ]

I have a Janitrol A/C and heat pump system. I replaced the thermostat with a Lux T9000LC The A/C works fine, but the heater does not. I have it wired as follows: G - Green Y - Yellow W - White RH - Pink B -

Bonus Room heat/air [ 11 Answers ]

Hello, I'm finishing off a bonus room upstairs, which is roughly 370 sq ft (26 ft x14.5 ft). I'm planning on installing a mini-split system instead of tying into my existing heat/air system (don't think the furnace/AC is big enough). I'm not sure on what to go with in size, 12KBTU, 15KBTU or...

Changing from gas heat to electric heat [ 3 Answers ]

How do you change from Apollo gas heating system to electric heating system?

Electric heat pump auxilery heat problem [ 4 Answers ]

Equipment: Trane XL1400 4 years old Auxilery heat: Strips... 2 -60Amp circuits Filters changed every 30 days I cleaned outdoor unit summer 2006, as every year. Thermostat: Honeywell Chromotherm II Problem: I have been noticing at times the aux heat kicking in at times I think it should not....

Trouble getting heat to 2nd floor [ 3 Answers ]

I live in a two floor home where the thermostat is on the first. The trouble is I am having trouble getting heat to the 2nd floor. Is there any thing I can do to the vents on the 2nd floor that would allow heat to reach up there?

View more questions Search