Ask Experts Questions for FREE Help !
Ask
    raysanta's Avatar
    raysanta Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Oct 22, 2011, 03:01 PM
    Intertherm oil furnace
    Furnace kicks in; flame ignites runs 30 seconds or so then shuts down; 10 seconds later fan kicks in dumps warm air then shuts down; is this a cad cell problem?
    Handyman2007's Avatar
    Handyman2007 Posts: 988, Reputation: 73
    Senior Member
    		  
    #2

    Oct 22, 2011, 06:21 PM
    Is this a waste oil furnace? I have installed a few of these.
    Take the burner out, and CLEAN EVERYTHING. Turn all power off to the unit and clean everything. It could be the CAD but it's more than likely dirty. Also check the chimney flue... if anything is leaking or blocking it, the furnace will not run. Good Luck
    raysanta's Avatar
    raysanta Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Oct 23, 2011, 09:11 AM
    Not a waste oil furnace, this an older model intertherm oil furnace model #MSH 080 AA (hard to read) that has only run on arctic stove oil. I change line filters (2) and nozzle. Bled the line and restarted furnace, this has always worked in the past.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Intertherm furnace codes? This furnace flashes the yellow light 6 times [ 0 Answers ]

Furnace will run for 30 seconds. It shuts down and the yellow light will flash 6 times and the does the same thing over and over. Red light stays steady. Thanks for the help.

My intertherm furnace will not come on fuel oil [ 0 Answers ]

Bryant oil furnace (#369AAN) with Beckett AFG oil burner [ 1 Answers ]

I was curious as to if anyone can tell me anything about the above product(s). Reason being is because I had no choice in which new high-efficiency furnace would be installed. I have a home warranty through AHS (which is horrible) and this is the product that was installed. Is Bryant as good as...

Intertherm furnace e2eb-017hb runs briefly, shuts off, then furnace just clicks [ 3 Answers ]

I have an Intertherm furnace, e2eb-017hb. It comes on briefly, blows warm air, then shuts off, and a clicking sound comes from the coil contacts area. I have tested the t-stat, and also replaced a coil contact, thinking that was the problem. I would appreciate any help on what to do next.

My intertherm furnace pilot lights but furnace won't kick on [ 5 Answers ]

I need some diagnostic help. We have a full propane tank. A new burner plate (last year) and the blower works. We light the pilot but the knob should pop up after one minute thus lighting the furnace. It won't pop up. What part should we replace? The furnace is a 17 year old Intertherm MGH...

View more questions Search