Ask Experts Questions for FREE Help !
Ask
    grandmommypam's Avatar
    grandmommypam Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 20, 2011, 09:44 PM
    Replacement etched glass panel
    Looking for an etched glass panel for a dining room chandelier. Has a hope in it for hanging from a wire peg on chandelier. I believe the light has 6 or 8 panels plus a center drop down spot light. Bought from Home depot 6-8 years ago. Could be a Hampton Bay light.
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    Oct 22, 2011, 08:32 PM
    Unless you are very lucky, you will most likely not find a direct replacement. You may be able to buy a size match and then get some glass etching solution and try it yourself. Michaels sells it.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Glass replacement [ 3 Answers ]

I purchased a 5 piece hampton Bay patio set this past summer, and the glass just shattered today for no apparent reason no one and nothing was near the table please someone get back to me about a replacement.

Microwave glass replacement [ 1 Answers ]

What type of glass is used in microwave doors? And it safe to simply replace the glass, rather than replace the whole door for approximately $200 on a microwave worth less than that? What is the technology behind stopping micro waves?

Scanner Replacement Glass [ 4 Answers ]

Does anyone sell just the glass? Any problems with just getting a piece cut from local glass shop? Tinting, Filtering?

Solar panel glass [ 2 Answers ]

I would like to know the definitions of flexi glass and plexi-glass. I also would like to know if a person can use plexi-glass on a solar panel with the same results that flexi glass would give.

How do I caulk vertical voids at a glass panel? [ 1 Answers ]

I have a fixed 7' glass panel that is 1/4" distance from a stone wall in a shower. The glass panel was designed to be fixed at only the top and bottom and to "float" off of the stone. However, moisture enters through the 1/4" wide x 7' void, damaging the adjacent gypsum board. I would like to...

View more questions Search