Ask Experts Questions for FREE Help !
Ask
    dollarlawler's Avatar
    dollarlawler Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 20, 2011, 07:01 PM
    Carrier furnace gas valve won't open .
    Hello, I have same problem as skoobahead. So I decided to jump 24v straight to gas valve and it did open up. I only show 15v at valve also. Board is new.
    T-Top's Avatar
    T-Top Posts: 1,871, Reputation: 100
    Ultra Member
    		  
    #2

    Oct 20, 2011, 07:06 PM
    It may sound like the same problem but can be totally different. As much info that you can give about your system will help.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

I have a mueller climatrol furnace and the gas valve won't open or stay open. [ 0 Answers ]

I have a mueller climatrol furnace in which the gas valve won't open or stay open. We think it is electrical problem. Back in the summer, my air went out and a friend did wiring to bypass so the air would work for time being. At that time, before the bypassing to get air to work, the heat...

Carrier furnace gas valve? [ 0 Answers ]

Have a carrier 58RAV. It was just running the blower constantly, per troubleshooting I replaced the board. Now everything runs during the test cycle but when after hot start ignitor glows and my volt meter starts to read volts going to the gas valve I hear a click and the hot surface ignitor and...

Carrier Natural Gas Furnace main gas valve will not open every call for heat [ 1 Answers ]

We have a Carrier Weather Maker 8000 Natural Gas Furnace not functioning properly. We have replaced pressure switch, hot surface ignitor, flame sensor and control board. It will cycle 3 to 4 times and then not come back on. Is it possibly a bad coil on gas valve?:rolleyes:

Carrier furnace gas valve won't open [ 8 Answers ]

Hello, My carrier furnace is on the fritz. I am receiving a 34 code which states"ignition proving failure" The blower fan starts and the hot surface ignitor lights but no gas flows. I replaced the ignitor with a new one-no help. The flame sensor is clean.When I check voltage at the gas valve...

View more questions Search