 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
John Deere L110 rear axle
The top of my transmission shaft, near the pulley, is not centered in the hole in the sheet metal belt guard above. Rather, the shaft is shifted forward 1/4 inch or more, and slightly to the left, and has been running against the belt guard. Is this any concern?
The mounts for the belt guard, slots on left and screw on right, don't appear to allow any float or misalignment on the frame rails. Do the axle's mounts somehow allow some float in where the axle mounts? When I replace the belt and fan, should I (can I?) try to move the whole axle to align the shaft with the hole in the belt guard? Any help appreciated! Jim Boston, MA |
||||
|
||||
|
Thanks to anyone who might have read through or been thinking about my question. I believe I found the problem - As I got into replacing the fan and pulley, I found the transmission has two straps that mount its front to the frame. The left one was rattling loose, and the right one was broken clean through! It's pretty clear now that the transmission's weight, without proper mounts, is making it roll forward and left so the shaft hits the belt guard above. The new mount is on order; hopefully it will fix the alignment and maybe help keep the belt from coming off the pulley!
Thanks, -Jim |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I have a John Deere L110 with a Kohler 17.5 command motor. When I go to start it I cannot get it to start. I checked the fuel pump and it seems OK and checked for gtas at the carb and it seems OK. If I pour gas into the carb from the air breather it will start but soon dies I have a wire running...
I have a John Deere L110 in the Manual it give me the Gap Size for the Spark plug but Does not give me info on the Plug itself, What Manufactor is the plug and the Plug Number? I can not read what is currently on the Org plug. Thanks for your time, Chris
I have a 2003 John Deere L110. At the beginning of this mowing season, when I cranked it, the engine tried to crank with it in the run position and stopped cranking in the crank position! Then it just stopped cranking altogether. I replaced the ignition switch and that did not help. I replaced...
A stick broke two of the plastic fan blades on the fan that sits on top of the trans axle. The grand kids were using the mower for a dune buggy. Anyhow I think its called a trans axle this is causing the belt that rides on the fan pulley, to vibrate quite bad. I want to replace the fan. Any advise...
John deere model L110 Mower was working fine. I got off it to add more gas, when I got back on it would not start. I turn the key and nothing, no clicking, nothing. I disconnected the pressure switch from the seat and still nothing. Mower blades are not engaged. What am I missing, it still...
View more questions Search
|
