Ask Experts Questions for FREE Help !
Ask
    edensreign's Avatar
    edensreign Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 18, 2011, 07:26 PM
    Miller M1M Furnace 2 Red Flashes Combustion Fan Runs
    I've got a Miller M1M Furnace. The thermostat kicks on, the combustion fan activates and then the red light flashes twice. The control light status says 'Pressure switch open with inducer on.' I'm guessing this means I need a new pressure switch. Any way to test the pressure switch to make certain? Or should I just replace the switch? Any help's appreciated.
    JonesHVAC's Avatar
    JonesHVAC Posts: 173, Reputation: 12
    Junior Member
    		  
    #2

    Oct 18, 2011, 08:23 PM
    You need to see if it is a normally closed or normally open pressure switch, labeled on the switch, and then use a meter to check for continuity. I would check before operation and after operation. Your inducer motor could be bad too.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Evcon Furnace 3 Flashes Combustion Air Switch Failed to Close. How Do I Repair It? [ 2 Answers ]

Evcon Central Furnace fault light flashes 3 times, combustion air switch failed to close, how do I make repairs?

Miller M1M furnace will not ignite. I have 2 red flashes [ 5 Answers ]

I have a miller M1M gas furnace. It will not ignite. The red led is flashing 2 times. It says the pressure switch is open. Does this mean the pressure switch needs replaced? Or is there something else wrong. How can you fix this problem? Thanks!!

Powerspec light flashes fan runs but won't boot [ 3 Answers ]

Computer has been sitting for over a month without being turned on. When I did, it sounds like it is going to start up, but it does not. Two orange lights come on and a yellow flashes. No Beep sound, but a "turning" sound like something keeps turning over... and not catching. Nothing comes on...

Miller furnace m1m with 1 red flash and the draft motor won't shut off? HELP [ 0 Answers ]

Miller furnace with 3 red flashes [ 1 Answers ]

I have a miller mobile home furnace about 11 years old... I have been having problems with it not "kicking" in no matter what I have the heat set at. Now it won't start at all. The error code is three red flashes. What does that mean?

View more questions Search