Ask Experts Questions for FREE Help !
Ask
    maybets's Avatar
    maybets Posts: 1, Reputation: 1
    New Member
     
    #1

    Oct 17, 2011, 03:19 PM
    I have An Enviroplus 90 furnace The blower is running but the burner is not I have no
    Blower won't stop running & it has no heat
    drtom4444's Avatar
    drtom4444 Posts: 3,282, Reputation: 145
    Ultra Member
     
    #2

    Oct 18, 2011, 07:09 AM
    It sounds like you either have a bad fan relay or bad t-stat that is keeping the blower on, but you will have to use a meter to find out why the heat will not come on. Get a meter and learn to use it, then check to see if you have 24 volts to gas valve when the t-stat is set to call for heat. Check to see if there is 24 volts between the Red (R on thermostat) and White (W on thermostat) when the t-stat is set to call for heat. If so, the t-stat is not closing the contacts to supply voltage to the gas valve. Check the power to the coil on the fan relay and if you have 24 volts after putting t-stat on "Auto" you have a shorted t-stat. If there is no voltage to fan relay and fan is still running you have a stuck relay and you need to replace it. On a fan relay you should be able to trace the wires to find the coil wires-they are usually two terminals on one end of the relay. Hope this helps. Note that when reading across a switch when you read no voltage the switch is closed and when you read voltage the switch is open. DrTom4444

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Furnace burner won't shut off but blower does. [ 1 Answers ]

Gas Furnace Issue: With this I keep the gas burner and the blower as separate components. My gas burner will usually shut off before the blower, but a couple of times in the last three days it has not. I will hear the blower shut off and the burner will remain on. As far as I know the burner would...

Furnace burner cuts off when blower kicks in [ 7 Answers ]

It's a Goodman GUPI100-4. Everything appears to work right until the furnace blower kicks in. Then the burner shuts off and the blower fan continues to run until I guess it cools down to its limit. After a minute or two it goes through the same cycle. HELP.:)

Carrier furnace blows 3 amp fuse after burner and blower fan have been on For a while [ 0 Answers ]

Carrier furnace with 4 LED control board 3 amp fuse opens after burner and circulation fan has been on for awhile 26Vac pulls down to 8 volts ac Replaced with 5 amp fuse and it does not open and furnace operation seams normal. Valve control is a White Rodgers 36E What should the resistance of...

Furnace Blower Won't Run Until Burner Quits [ 1 Answers ]

I have a 20+ year-old Carrier gas fired furnace that is logic controlled (that is, it has an electronic control unit in the top of the fan compartment). For some time, instead of starting the blower fan as it should after the burner has come up to a certain temp, the burner just runs until it...

Furnace blower going but burner not igniting [ 1 Answers ]

My furnace was going on and off very frequently for the past two days. Now the blower is going but the burner is not going on. Any ideas?


View more questions Search