Ask Experts Questions for FREE Help !
Ask
    rhahar2112's Avatar
    rhahar2112 Posts: 3, Reputation: 1
    New Member
    		  
    #1

    Oct 16, 2011, 05:16 PM
    Icating low flame s
    Upon closer inspection the yellow light flashes while running indicating low flame sensor as indicated by the panell instruction

Check out some similar questions!

Pilot stays on, burner is on but very low flame and hot water is gone. [ 0 Answers ]

Chain pull hunter, no middle speed. Starts high, then low, then low, then off. [ 1 Answers ]

Three speed hunter ceiling fan. 8 years old. Pulling chain was guessing game. Never knew what speed you'd get, Had to keep trying to turn off, never worked like it should. Had a handy man put a new switch in, now it starts in high speed, then low speed, and low speed again, then off. Can't get...

Beckett burner starts has flame for about 15 seconds off for 12 then flame on & runs [ 7 Answers ]

I have replaced the following with the problem still happening: replaced the primary control(R8184G 4009), cad cell--the oil unit was service at the beginning of the heating season. Ran like a champ. Now for the past two weeks with new parts the problem is: Oil burner starts with a flame for...

Magic chef low flame [ 0 Answers ]

I bough a used magic chef 34jk 5tkxw the top burner flame seens a bit low... I remember on some models the flame could be adjusted just under the burner top... a nut there to turn... I don't see one on this stove... is the main preasure adjustable? Or can...

Flame on - fan on - flame goes out [ 1 Answers ]

Thermostat calls for heat, ignitor comes on, burner lights, when hot enough for the fan to come on the burner shuts off. The fan runs for awhile and the ignitor comes back on, lights the burner, runs for a short time and everything shuts off. Then the cycle starts all over again but does not reach...

View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.