 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Furnace blower issues
Inside furnace blower only runs when by-pass switch is thrown. The fan will not operate normally with setting on the thermostat, I also tested with a different thermostat. Prior to this I was getting a humming noise from the fan. Is this possibly the starter capacitor?
|
||||
Check out some similar questions!
I have a ruud unit model ugda075cer. About a week ago it started to make a sound,squell, when it starts to turn, 5 second. After about 5 seconds the sound stops. The blower would work. I was told the blower needed to be oiled. I read manuel did as it said. I was told I needed a 10 to 20 weight...
My thermostat is a white /rodgers module this clicks to start but no air blowing from the furnace in the attic which is a trane model and the same with cold air the thermostat clicks the ducane model outside whirs but no cols air.
Trying to learn small engine repair. Came into a Craftsman 32cc 2-cycle blower, mod # 316794970, which has not run since it's owner was given it. I've got spark, fuel is getting to the plug, won't start with starting fluid. Cleaned it up, replaced the reed (the support arm was mysteriously chewed...
Hi all, I have a older Coleman Evcon natural gas furnace model BGU07512A that has started having a problem. The blower motor quits at the same time the burners shut off. Would this be a limit switch problem? Thanks a lot!
In cool mode fan will work on all 3 positions. On auto and inter. But in heat mode fan will only work in the on position.will not kick on in auto or inter. Position. I've been advised its probably a bad relay. Is this 'probably' true. And if so how do I change it? Model(-)BHA-17 H 11 S U B A this...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
