Ask Experts Questions for FREE Help !
Ask
    Jacko1002's Avatar
    Jacko1002 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 2, 2011, 02:09 PM
    Janitrol furnace with no flame
    I have a janitrol gas furnace gmpn-080. The glow plug heats up but there is no flame. Bad valve maybe or something else?
    Thanks
    T-Top's Avatar
    T-Top Posts: 1,871, Reputation: 100
    Ultra Member
    		  
    #2

    Oct 2, 2011, 05:30 PM
    It can be a bad valve or dirty a burner in front of the ignitor. Make sure all gas shut offs are on, make sure gas valve is set to on. If the gas valve is opening you should hear the gas release into the burners.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Janitrol furnace [ 5 Answers ]

I hit the power on my furnace and the board hums for a few seconds and then blinks three times . Ihave checked for blockage in vent and is fine. Ihave blowed pressure switch and it clicks is it the switch board or air blower that won't start.

Furnace blower will not stop after flame goes out on gas furnace [ 1 Answers ]

Furnace blower will not stop after flame goes out on a gas furnace

Janitrol Furnace [ 5 Answers ]

Hello - I have a Janitrol Model # GUE060-E Furnace. The blower will not shut off unless I power it off by removing the bottom panel. I hear a clicking sound like it wants to shut off. The thermostat is set to auto mode. Could it be the relay? Thanks, Dan

No HSI start GMNT Goodman Janitrol No flame start [ 1 Answers ]

I have a Janitrol (Goodman) furnace, and the controller board indicates 3 blinks. The flame blower starts, but it never gets to HSI (the ignitor never starts heating up). I've changed the controller board, and same issues. I've been through every sensor (bypassing all of them), and still no...

Janitrol furnace [ 4 Answers ]

I have to down to the basement and manuel turn the blower on it will not go on on auto only manuel what do you think is wrong thanks tboy56

View more questions Search