Ask Experts Questions for FREE Help !
Ask
    chandramauli's Avatar
    chandramauli Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Oct 1, 2011, 10:50 AM
    How to reduce rpm drop in tractors?
    When a tractor reaches to a gradient its rpm drops, so to reduce the rpm drop so that it can easily go up the gradient what measure should be taken? Please reply fast
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #2

    Oct 1, 2011, 01:37 PM
    . Adjust idle rpm.

    . Clean/replace air filter.

    . Replace spark plugs, if they have not been recently changed and it's not a diesel. Go over the ignition system, ensuring the battery is fully charged and that battery terminals and connections are clean and tight. Ensure spark plug wires, rotor, coil, and distributor cap are in good shape.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Tub drain need to drop 26", btr to drop at 45 or 90? [ 5 Answers ]

Hello All, I'm installing a shower and have been scratching my head on this for a while. I need to run the drain along the wall above to so I can vent it (for a foot or two), then hang a right and head toward the stack about 5' away. Due to the small crawl space and T on the stack, I need...

Wind force 100 lbs ,torque 300 ft ,rpm generator 500 rpm =? Hp [ 3 Answers ]

Honda accord engine revs up 4000 rpm and down to 0 rpm when starting [ 5 Answers ]

When starting, Honda Accord '82, engine speed goes very high 4000-4500 rpm, and immediately after that stops. The effect is repetitive. However, after pressing a gas pedal repeatedly 2-3 times per second it is possible to maintain the engine speed in the interval of 2000-3000 rpm, and doing so it...

Reducing rpm on drop saw electric motor [ 1 Answers ]

:eek:Hi, I am wanting to be able to reduce RPM of metal cut off drop saw motor from 4000 rpm to 2000 rpm approximitly. Thanks if you can help.

88 Civic Wagon: Bogging below 2500 rpm and hard studder and 4000 rpm. [ 7 Answers ]

Hello all: I have a '88 Civic Wagon with 220k on a D15B2 (DPFI) engine. Just recently I have started having the problem above. Mostly once the car is warmed up. The car will choke, sputter, and try to stall even at full throttle below 2500rpm. After 2500 rpm the engine spins to life and runs...

View more questions Search