 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
Check out some similar questions!
I have A Heil Furnace that starts up just fine Model #NDG1075DFo1, but after its running for 5 minutes or so it gets another call for heat, fills the gas box with naatural gas and re-lights this mix pretty violently. This may happen a few times during the heating cycle until the thermostat is...
I need a new heat pump and have estimates for Trane XR15 and Heil performance15. Is one really better than the other? I have searched complaints on these and other units. Honestly, they can all have their issues. Thnaks [email protected]
We have a Heil 7000 propane furnace. We had it installed in 1993 and haven't used it much over the years. This year when we started using it the motor had froze up and we replaced that part. Draft/flue inducer. I think is what it was called.Anyway after we reinstalled the part now the ignitors...
Diagnostic code lo pressue switch open when should be closed on two stage. Only on first heat cycle/lo. Does it need new lo pressure switch? Or simpiliarfix?
I have bought a house with a furnace and I cannot get the pilot to light. I am asking for some type of manual so I can figure this out. The model is VG-80MD-1 and the serial is H73838067. The house was built in 1977 and I am sure this is the original Thanks for any info
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
