Ask Experts Questions for FREE Help !
Ask
    GLRinehart's Avatar
    GLRinehart Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Feb 1, 2007, 08:18 AM
    Honeywell RTH230B Thermostat not following program
    I have a Honeywell, #RTH230B programmable thermostat, but it is not following its program. Manually, it works fine. I have changed batteries. Is there some way to totally reset it, to fix it?
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #2

    Feb 1, 2007, 04:50 PM
    Open and disconnect the face completely, remove the battery. Reassemble after a few minutes, this is like a hard re-boot. You will need to re-enter you whole program. To save time try just re-entering one program change rather than the whole deal.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Honeywell RTH230B thermostat [ 39 Answers ]

I am trying to wire a Honeywell RTH230B thermostat. The existing wires are Yellow, Green, Red and Black The ports available in the new system are W, Y, G and the Rc and Rh terminals are jumpered. Which wire do I put in the W port? (Red or Black), then what do I do with the one that is not...

Honeywell rth230b thermostat [ 3 Answers ]

We hooked up the honeywell programmable thermostat and it was working fine for 10 days or so until this weekend when the temperature should be at 67 all day from 6am to 10pm and 62 from 10pm until 6am on sat and sun. this weekend the thermostat does not bring the temp up to 67 but it leaves it at...

Honeywell RTH230B Thermostat [ 1 Answers ]

I recently installed Honeywell #RTH230B thermostat to replace and old Honeywell # T87F( old round non digitital type). I have oil burner with basebaord water heat. Since my olf thermostat was 2 wire only and I have no AC I pulled the jumper wire between Rh and Rc as per the instructions. Thj9is...

Honeywell Thermostat RTH230B [ 14 Answers ]

I have 6 wires to connect. The colors are as follows: W, Y, G, B, O, and R. The thermostat calls for W, G, Y, Rc, and Rh. Where do I plug in the R and what do I do with the B and O? Any help would be greatly appreciated. Thank you

View more questions Search