 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Locating the fuse in a furnace?
Just reading about the fuse problem on this page.
It might or might not be the fuse,. who knows! Usually when I turn on my A.C. unit (usually from the thermostat), I would hear (1) click, and then from the outside A.C. unit would turn on, finally the compressor (I think )! Would go on. So a total of (3) stages to turn on the A.C. But lately I hear the outside A.C. would only turn on once since the last one would turn on just about 2 seconds, then would shut down. It's like it's trying to turn on but could'nt,. don't know what to do. |
||||
|
||||
|
Not knowing what fuse you are talking about, I can pretty much tell you if the fuse to furnace is bad nothing works. You need to get up close and personal 1st with the furnace does the blower come on when the tstat is set for cool /heat/fan only. If so go out to the ac/condenser unit is it working? The fan and the compressor whis is inside the condenser unit and starts up at the same time as the outside condenser fan,,
Do all this and let us know what you have found out |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
Can someone send me a picture of pilot light and how to light it. My furnace doesnot have a knob for pilot light. There is a ON and OFF position.
Bryant 383KAV024070AGJA furnace not working after intall of Honnywell humidifier 360 (pered fan). Flashing LED 2-4 suggests "24 v secondary fuse open". How do I replace/reset fuse and how do I wire the Humidifier correctly this time?
E fuse in Carrier gas furnace, model 58MCB, keeps blowing. Should a different fuse be used, or is the problem likely in a component.
I was changing the pipe insulation on my exterior units( now I hear this is not necessary) when the power went off on one unit. I checked the breakers, turned off the power and checked the small wires outside. The insulation on the wires had deteriorated so they may have touched each other causing...
I have a Comfortmaker Furnace (approximately 1998/99) and the fan will not turn on allow the furnace to heat. When I try to turn the furnace on it blows a 3 amp fuse at the blower motor. I removed the fuse and jumped it and all it will do is make a faint buzzing noise and not turn on. I can...
View more questions Search
|
