Ask Experts Questions for FREE Help !
Ask
    dprost's Avatar
    dprost Posts: 3, Reputation: 1
    New Member
    		  
    #1

    Jan 28, 2007, 03:14 PM
    Furnace issue
    The burners kick on for about 5sec and then kicks off. This cycles a few times and then shuts down.
    NorthernHeat's Avatar
    NorthernHeat Posts: 1,455, Reputation: 132
    Ultra Member
    		  
    #2

    Jan 29, 2007, 11:28 AM
    Quote Originally Posted by dprost
    The burners kick on for about 5sec and then kicks off. this cycles a few times and then shuts down.
    See this
    dprost's Avatar
    dprost Posts: 3, Reputation: 1
    New Member
    		  
    #3

    Jan 29, 2007, 04:38 PM
    Quote Originally Posted by dprost
    The burners kick on for about 5sec and then kicks off. this cycles a few times and then shuts down.
    Thanks, but I cleaned out the tubes the gas travels through before it ignites and the furnace is working fine.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Wiring a furnace thermostat to manually operate the furnace fan [ 2 Answers ]

I have two wires connected to my furnace thermostat. There is a place labeled G on the thermostat. Can I simply run a wire from the G terminal on my thermostat to the terminal labeled G on my furnace fan relay to operate the fan separately?

My intertherm furnace pilot lights but furnace won't kick on [ 5 Answers ]

I need some diagnostic help. We have a full propane tank. A new burner plate (last year) and the blower works. We light the pilot but the knob should pop up after one minute thus lighting the furnace. It won't pop up. What part should we replace? The furnace is a 17 year old Intertherm MGH...

Thermostat and/or Furnace Issue [ 4 Answers ]

I am new to the board and I hope that I am not repeating this situation. I have looked through many of the situations that others have had, but couldn't find the answer to my problem. Here it goes. I have a Honeywell programmable thermostat (not sure the model number, but it is approx. 5 years...

Goodman Furnace Issue - Heater won't work, no fire [ 1 Answers ]

My Goodman heater won't fire up. When I turn the heat on, the sequence of events: 1) Small fan at top section turns on. 2) Heating element turns on, bright red. The system sounds like it is trying to turn on. 3) Then the bright red goes off. The fire does not light. The fan does not start 4)...

Comfortmaker Furnace Fan blows in line fuse and will not allow furnace to work [ 1 Answers ]

I have a Comfortmaker Furnace (approximately 1998/99) and the fan will not turn on allow the furnace to heat. When I try to turn the furnace on it blows a 3 amp fuse at the blower motor. I removed the fuse and jumped it and all it will do is make a faint buzzing noise and not turn on. I can...

View more questions Search