Ask Experts Questions for FREE Help !
Ask
    wolfe2166's Avatar
    wolfe2166 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Jun 3, 2011, 07:28 PM
    Sx95 clutch
    I have a John Deere sx95 that has just had the drive belts replaced. It now shifts hard and the clutch doe,s not seem to disengage. Is there an adjustment on the clutch? If so what are the proper tolerance,s?

Check out some similar questions!

John Deere, sx95 [ 1 Answers ]

How do I remove the drive belts, from the engine to the rear axle?

How to build pressure 2001 honda civic clutch slave and clutch master [ 1 Answers ]

I have replaced clutch slave and replace the clutch master kit... tried bleeding it but there is no pressure, How do I get pressure to build... also clutch pedal is stuck and won't retract.

Clutch [ 6 Answers ]

I have a 1986 Celica Toyota GTS and the hydraulic clutch burnt out. I tried adjusting it but then it just burnt out again. I am assuming that I will need to replace the clutch but I'm not sure how to find a cheap part. What would I look up? What would I need? I have a 1986 Celica Toyota GTS car....

Deck belt threading sequence john deere SX95 [ 5 Answers ]

Replacing the deck belt on a johndeere sx95. Anyone know the correct threading procedure? Thanks, Mark

View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.