 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
3 way erie zone valve
I have a amana 70,000 BTU dc motor furnace.I need to know how to wire a erie 3-way zone valve.I am going to put a outside wood boiler in with a heat exchanger on the furnace, it is a counter flow.when the furnace call for heat the zone valve open and the motor ramps up to high speed. Then when it goes back to by pass the motor goes down to low speed to keep the air moving in the house.someone told me to put a pump there not the zone valve I nt sure about that. Need help please thank you./////
|
||||
Check out some similar questions!
Honeywell zone valve
[ 1 Answers ]
The valve does not open when I call for heat. The manual lever is stuck in one position and I am unable to move it in any direction. I have an older style valve which I suspect I have to replace. Will the new motorized valve mount to the old body or do I have to replace the body as well?
I have a weil-mclain boiler. The zone valve opens but no heat in zone. What do I do?
[ 1 Answers ]
Have replaced the zone valve actuator, but it doesn't seem to be fixing the problem. What else can I do?
Inverted zone valve
[ 6 Answers ]
Hello, I have a 2 zone hydronic controlled by 2 Erie zone valves (model 465B327 30 A1). Boiler was replaced from house lately. Without power applied to zone valve motor, valve lets water flow pass. (normaly on) According to this:
Zone valve
[ 1 Answers ]
Got a white rogers zone valve spinning and not stopping ,has my end switch burned out .
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
