Ask Experts Questions for FREE Help !
Ask
    Allan6512's Avatar
    Allan6512 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    May 28, 2011, 11:35 AM
    How to vent city sewer lines?
    I have a restaurant on the high side of a shopping center. We have installed odor hogs on everyvent as well as gaskets on the grease trap lids. Wax rings were replaced on all water closets. The building has been power smoked four times. We are eliminating negative pressure at this time. Someone mentioned an item called "trap master." Can someone tell me anything about this and can I get other suggestions. We are on the end of the sanitary line from the shopping center.

    Thanks,

    A
    Allan6512's Avatar
    Allan6512 Posts: 2, Reputation: 1
    New Member
    		  
    #2

    May 28, 2011, 11:48 AM
    Sewer Odors
    I have a restaurant on the end of a shopping center sewer line. We have power smoked the vents 4 times with no leaks. The wax rings have been replaced and gaskets were installed on the grease trap lids. We have installed "odor-hogs" on all vents. We are eliminating negative pressure on the building at this time. Someone mentioned a device called " Trap Master." Can you give me any suggestions or tell me about the Trap Master.


    Thanks,


    A
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

What must acid waste go through before discharged to the city sewer? [ 2 Answers ]

How to read city sewer plot digits? [ 1 Answers ]

City gave me a plot to help us determine sewer connection that is clogged near one connection. Service people found a clean out 100' away and cleaned some roots until blocked. Further service needs $1000+. On the plot one connection is marked as 0+00(60)"Y", another is 0+98(60)"WYE". What does...

Sewer hook up to city riser [ 3 Answers ]

Good morning: Have a 50' run to city riser, according to my calculations I need to hook up to the riser appx. 12.5" down the riser from ground level to give the run 1/4" per Ft. . What fittings do I need to hook up to a 4"riser? I assume it's a sweep surely not a 90 degrees. Thanks in advance ...

Need to know which way city will be snaking my sewer line [ 2 Answers ]

My sewer line is getting snaked by the city tomorrow for a clog. I was wondering what's the odds that I would still have to call a plumber to snake from my house. A few plumbers told me that the clog is probably between my cleanout and the curb so the city would have to snake from my house. They...

View more questions Search