Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Is it OK to "finish" a garage with OSB, and do 2x4 trusses need to be beefed up?
[ 7 Answers ]
(I submitted this question before, but perhaps the poor title didn't hook any readers) I'm thinking of "finishing" my connected garage with OSB instead of drywall, it would be faster, cheaper and easier. Are there any good reasons NOT to do this? Any opinions in favor? (Note: the wall shared...
Garage door problems
[ 3 Answers ]
My garage door is activated by the keyless entry button for my car and also the neighbors key works my door. I think everyone may open it. What's up? Kevin
Garage Door Problems
[ 1 Answers ]
My Buddy has a garage door opener. It's a Legacy from Overhead Door Company. The "opener" i.e transmitter on the wall is a Code Dodger. The receiver is a Multi Code. Here's the problem. The original receiver went bad and Overhead came out and replaced it. It now works fine with the exception...
Garage Settling/ Foundation Problems
[ 1 Answers ]
Hi, I bought a 20 year old house 6 months ago. The garage floor has settled and it slopes down in the middle. If it rains the water will pool into the middle of the garage floor. Additionally, the garage wall closest to the house sits directly above the basement wall.(see attachment) The corner...
Garage door problems
[ 1 Answers ]
I have a craftsman 1/2 hp garage door opener and it does not stop when it fully closes. It starts to buckle, and it also does not go all the way up, only about 1/2 way. I am not really familiar w/gdo's, can you offer some ideas. Thanks, Mark View more questions Search
|