 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Payne PY3P. Hardware failure?
I have a payne PY3P dual pack unit. I have power from service panel all the way into the unit. Led code indicator is off. Sticker calls this a "Hardware Failure" Unit will not power up, no fan, no heat, no ac, no sounds at all when attempting to activate. Is this error code referring to the main board?
|
||||
|
||||
|
Never mind, after stressing for an hour I found Im actually only getting 110v to my service disconnect on back of ac. 240v out of brand new breaker. One dead line somewhere from service panel breaker to service disconnect. Ha now for the fun stuff. Running new wire!
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I replaced the gas valve yesterday morning, by 8 pm the same problem happened. I noticed the circuit board was not flashing any fault codes and was not locking the furnace out. i.e. the ignitor glows and the gas valve circuit energizes for a moment ( with wires attached to gas valve) and then...
My computer recently experienced a series of problems, before refusing to start up at all. It wasn't recognising any of my DVD drives which prevented me from wiping the HD and making a fresh XP install. After borrowing my friend's external DVD drive I was finally able to do this (the 3rd time round...
I have a gateway pentium d computer its not bad... i formated again ( delete everything and start over) now i'm trying to go to add a hardware but it says put in the installation cd , i put the windows ex cd, when i try to add a device it says i need to connect to the internet, how can i connect to...
I am trying to find out what kind of a motherboard I have in a system that was given to me. I can not find any markings on it so I think that it is a generic board. I think I remember a program that you can run that will give you all the info about your system. Is there anyone out there that knows...
View more questions Search
|
