Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
What causes a 15.5 Briggs & Stratton engine to not start?
[ 4 Answers ]
My Sears mower has a 15.5 briggs and stratton engine that is 6 years old and is having trouble starting. Sometimes when I turn the key, the motor will turn 3/4 of rev and stop due to hard compression. I can hand turn the engine past this sport sometimes and the engine will begin to turn over. Even...
Briggs & Stratton cranks but does not start
[ 11 Answers ]
I have an MTD Yard Machine powered by a B&S 12.5 hp code 9311064E type 0154-01. The engine cranks slowly and in spurts approximating the four cycles. When I remove the spark plug the engine spins normally. I had the battery checked at a battery shop and it was pronounced fine after a load test. A...
12 HP Briggs & Stratton will not start
[ 2 Answers ]
I have a 12 HP Briggs & Stratton Model 283707, Type 0148-01, Code 92042311. This engine broke a connecting rod. I have replaced the connecting rod. New rings also and do have it timed properly but it will not start. Turns over very good but will not start acts like it is not getting gas. New plug...
12.5 briggs & stratton won't start
[ 1 Answers ]
This engine is on a trail cutter. Never had a problem starting the engine before. The last time I used it all went well . 3-weeks later I went to use it again . Checked the gas and it was out. Filled the tank and did the usual start up procedure and it would not fire. Put a little gas directly in...
Briggs & Stratton 5 HP - cannot start
[ 2 Answers ]
I have a Coleman Powermate 2.2 kW 110 volt electric generator which uses a 5 HP Briggs and Stratton engine. I could start it without problems in December when we had a 4 day power outage near Seattle. It helped me out. Now I cannot start it. I tried new gasoline. By using ether (Faststart?) I... View more questions Search
|