I have a 5hp briggs with a pulsa jet carb.

texascountryboy Posts: 1, Reputation: 1

New Member

May 1, 2011, 05:04 AM

I have a 5hp briggs with a pulsa jet carb.

The engine runs good, its on a go kart. When my kids ride it it keeps on dying when you run it and let off the gas real quick any fixes or suggestions for this?

Check out some similar questions!

Briggs&Stratton Pulsa Jet Carb problems [ 9 Answers ]

I'm having trouble starting an older aerator with a B&S 3.5hp horizontal shaft engine with a Pulsa Jet carb. I've changed diaphragm, and carb-to-fuel tank gasket. It can be started and run on starter fluid, but doesn't seem to pump gas into carburetor. What else to look for?

B&S Pulsa-Jet Won't Fill "reserve bowl" (Fuel Pump Won't Work) [ 2 Answers ]

I have a 5hp B&S with a pulsa-jet carb (fixed jet). If I take carb off the fuel tank and manually fill reserve bowl, engine runs just fine for roughly 2 min then quits (reserve bowl is empty). The fuel pump diaphragm is wet when disassembled and looks brand new. I was given the rototiller with...

13.5hp I/C briggs engine backfires through muffler and carb [ 1 Answers ]

Hello,I have a briggs intek 13.5hp ohv single cylinder engine I just rebuilt.when I go to start it up I have to choke it to get it to start.while its running it back fires through the exhaust and carb.Also the govener hunts.If I choke it half way it will idle high and run without backfire or...

Gasket Placement on Pulsa Jet Briggs and Stratton [ 2 Answers ]

I just purchased a new gasket / diaphragm set for a Briggs and Stratton Sprint 3.75, Model 98902. The old one had the thicker gasket placed on top (the carburetor side) and the thinner rubber diaphragm on the bottom (the tank side). That looks upside down to me because of the flaps on the...

View more questions Search

Check out some similar questions!

Add your answer here.