Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
38608x12c murray lawn tractor
[ 2 Answers ]
It has been a while since I have rebuilt a starter for my murry rider . How do I hold the brushes in while putting rear cap back on . Have tried paper clips and starts to work but then they pop loose before it all togather. 12 hp single cylinder 38 cut 38608x12c date code 3160
My Murray 12.5 hp Lawn Tractor will not start
[ 1 Answers ]
Model 405004x99, 2 year old Tractor with a Briggs & S. 12.5 hp engine has a very hard time starting. It has a clean air filter; good in-line fuel filter, clean/fresh gas; oil is new and gets spark from the plug. I have had to jump start the battery from a car and (on a different occasion) a...
Re:Murray lawn tractor with 12.5 hp B&S .
[ 3 Answers ]
Starter motor spins but does not engage with the flywheel. The engine does not turn over and the starter just keeps on "singing"anyway. Has a new solenoid and new ignition switch so far, Battery shows 12 volts but may not be delivering the necessary cranking amps to crank over ?
Murray 12.5 lawn tractor won't go
[ 1 Answers ]
Murray 12.5 lawn tractor won't go into any gear. The runs but no movement forward or reverse
Murray lawn tractor
[ 3 Answers ]
I have a murray/stanley lawn tractor that has not been used in over an year. I replaced the batteries and added fuel and managed to start it up. I did also take the safety switch off under the seat since it was corroded. However when I take my foot off the clutch to move it or lower the blades,... View more questions Search
|