Ask Experts Questions for FREE Help !
Ask
    bearsfurnance's Avatar
    bearsfurnance Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Apr 17, 2011, 11:23 AM
    Inducer fan blade
    The inducer fan blade is broke furance is a bryant plus 90 cannot get part on a Sunday.can I reinstall motor without blade and run furance
    KC13's Avatar
    KC13 Posts: 2,556, Reputation: 99
    Ultra Member
    		  
    #2

    Apr 17, 2011, 08:41 PM
    No. The impeller is required to create an induced-draft and engage the pressure switch. P.S. DO NOT get adventurous & jumper the pressure switch. In the absence of an induced-draft, the burner flames will not be drawn through the heat exchanger. The likelihood of damage to the unit, as well as personal injury & property damage, is... virtually guaranteed.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

What is quieter a 3 blade or a 4 blade conderser fan [ 0 Answers ]

Is a 3 blade fan quiter than a four blade

Cooling Fan for Inducer Motor [ 1 Answers ]

The cooling fan for my furnaces inducer motor broke off when the HVAC guy was working on it. He said the part cannot be purchased individually, but the whole motor must be replaced for $400. Is this legit? It looks as though the plastic connection on the fan wheel broke and could be glued on. ...

Hot inducer fan... [ 0 Answers ]

I have a Coleman high efficiency furnace (5 yrs old.) that has ran well until this winter. My first problem was that the furnace indicated that the limit switch was open. I took it out, cleaned it, and then tested it (works). I put it back in and the furnace worked well for a couple of days. Then...

Looking for a draft inducer fan #621080 Anybody? [ 2 Answers ]

I'm looking for a draft inducing fan, part #621080. Any help would be great [email protected]

Draft Inducer won't start (it just hums unit I spin the fan blade) [ 2 Answers ]

When thermostat asks for heat, the furnace won't start unless I physically give the fan blade on the draft inducer a spin. What can be causing this?

View more questions Search