Hydro stat oil Change ?

Bill48624 Posts: 4, Reputation: 1

New Member

Apr 13, 2011, 06:55 PM

Hydro stat oil Change ?

I have a 2000 year 600 series mtd tractor with a Hydro gear 326-0510 hydrostat trans,Can I change oil in it ? And if so how do I drain it the parts diagram I looked at didn't specify a drain plug. Are there any manuals or support available ? Also I heard 5-50W syn. Motor oil is the best to use is this correct?--Thanks Bill

Check out some similar questions!

How much oil in a fill up of a hydro gear transaxle 218-3010l riding lawn tracker [ 0 Answers ]

How much oil does a hydro gear transaxle 218-3010l hold and what kind

John Deere Hydro 175 Oil Pressure Gauge [ 1 Answers ]

Hello folks! This 1990 JD Hydro 175 didn't come with the oil pressure warning light option and I just wondered if I could install an aftermarket mechanical gauge sensor in one of the two (now plugged) ports near the oil filter. Which port to use?? Is it likely to work?? Would really like...

Craftsman Hydro oil change [ 1 Answers ]

How do I change the oil in a Craftsman LT2000 Hydro Transmission? Model #917.273780 built in 2004. It loses power and speed when climbing an incline.

Wiring t-stat for oil burner [ 2 Answers ]

Wiring a thermostat on a new patriot oil fired furnace with a isolation relay and a transformer. The furnace is a Heat controller/patriot with a 7184 primary,there is a isolation relay with 4 wires -a red and a white that goes to the primary and they are connected to the TT terminals. Then...

Wiring digital t-stat to old oil burner furnace [ 1 Answers ]

I'm in the midst of replacing the original (by the look of it, 1930's-era) mechanical thermostat with a 44260 programmable digital model from Hunter. Wiring for the original thermostat: R - W - B. The W & B wires control the operation of the furnace, i.e. fire it. The R wire is for a heat...

View more questions Search

Check out some similar questions!

Add your answer here.