Compression

carwoman69 Posts: 1, Reputation: 1

New Member

Apr 10, 2011, 05:51 PM

Compression

No cmpression on cylinders 1,2,and 3 but compression on cylinders are 132 on 4,5,and 6

TxGreaseMonkey Posts: 16,761, Reputation: 5597

Uber Member

Apr 10, 2011, 05:58 PM

Blown head gasket on 1, 2, and 3? Did the engine ever overheat?

Add your answer here.

Check out some similar questions!

Too much compression [ 1 Answers ]

I have a 10 year old poulan lawnmower with a b&s 14.5 h.p motor it will only crank over to the compression stroke new starter and battery When I pull the plug out it turns over fine I drained the oil it had some gas in it changed it twice still the same trouble any ideas?

Old compression nut and compression sleeve [ 27 Answers ]

We have a shut off valve with a slow leak, about a teaspoonful every 10 hours. I want to replace the valve but the copper pipe to which it's attached is too short not allowing me to cut off the old compression sleeve. It's to my understanding that I may use the old compression nut and...

No compression [ 3 Answers ]

I have a 2.4L twin overhead cam, the engine does not start, I did a compression test and they were as follows, from battery 156, 0, 165, 175... and It seems that every time I crank the engine I have oil splashing or such at the back of my engine bay... Any help or tips would be great thanks.

Compression vs. Solder [ 6 Answers ]

Hi all. I have seen bits and pieces to the answer to my question in other posts, but not sure I have the complete answer, so I will ask it directly... Transitioning from copper to (C)PVC, are compression junctions adequate and/or recommended, or is it advisable to use soldered connections? ...