 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
wiring for Lux for PSP722E
I am having problems with the wiring for my old Janitrol multistage 24 volt heat pump system. The wiring is as follows
E(brown), G(green), Y(Yellow), R(red), O(orange), W2(blue), X(white) the wiring for the LUX is as follows G,O,Y2,Y1,RC,C,RH,W1,W2,E,B RC/RH have jumper wire. I think possibly the W2 and X and mislabled and if so do I hook up x as the common. |
||||
Check out some similar questions!
The colors are red, orange, yellow, blue, black, white and green. The options on the back of my LUX TX9000b are RC RH B W G O Y. IT seems most of these match up but with just one B on the back is it Black or Blue what goes to RC RH. I read red would go there but that leaves me with the extra B word...
I had a Janitrol HPT18-60 thermostat that I have replaced with the LUX TX9100E programmable thermostat and just want to make sure I have it wired correctly. I have a heat pump with emergency heat, the LUX does support 2 stage heat pumps. The Janitrol was wired as follows: Y = Yellow G = Green...
I just purchased LUX TX1500E thermostat to replace old CT87A Honeywell. The Honeywell was wired as follows: green – G, White – RC, Yellow – Y & W and Red – was not label, but I'm assuming this is the 24V power. I did wire the LUX TX1500E as it shown on the schematic for Heating and...
I am replacing a honeywell non-programmable with a Lux TX9000TS. The old wiring inputs show e, aux, y, g, o, l, r, b, c (with is optional with batteries) and the new lux is w,y,g,b,o,rc,rh,c. Which wires go were?
I have an American Standard Heat Pump with electric heat strips, I want to change the digital thermostat to a Lux programmable TX 9000ts. The american standard thermostat wiring is as follows R- red wire W2- jumper with a brown wire W1-jumper with a white wire Y- yellow wire G- green wire O-...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
