Ask Experts Questions for FREE Help !
Ask
    jendub88's Avatar
    jendub88 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Mar 26, 2011, 06:27 AM
    Coleman evcon troubleshooting?
    Our furnace is running, pumping warmish air. The thermostat is set at 68*, but our furnace doesn't seem to be able to heat our house over 61*. I've turned the thermostat and the furnace off and back on (the only troubleshooting I know!) with no results. It's a coleman evcon G FD024517A.
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
    		  
    #2

    Mar 26, 2011, 11:53 AM

    Watch to see if the flame is staying on, or if it goes out after a few seconds. Sounds like a dirty flame senser. You may be best off to have a pro into look at the system, as cleaning the flame senser on the colemans requires burner dissasembly.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Coleman evcon furnace model no. DGU10014UB troubleshooting [ 11 Answers ]

Coleman furnace referenced in subject line ignites, getting gas, blower starts, runs for a couple minutes, unit shuts down, red LED light on board blinks ten times. Anyone know the code for this repair? I'm FREEZING! :(

Coleman evcon furnace troubleshooting freezing inside coils [ 1 Answers ]

Coleman Evcon model number EB15B will only run on "Emergency" heat mode. Compressor froze over and coils are freezing.

Coleman evcon furnace troubleshooting freezing inside coils [ 0 Answers ]

Coleman Evcon model number EB15B will only run on "Emergency" heat mode. Compressor froze over and coils are freezing.

Coleman evcon troubleshooting? [ 1 Answers ]

I have the coleman evcon electric furnace -- the blower works -- but doesn't put out much heat -- rather warm not hot - the unit may be in need of cleaning not sure -- or is there a part that may need replaced.

Coleman Evcon [ 2 Answers ]

My mother has a Coleman Evcon dgat090800 the problem is that the burner will light up on it and burn until the blower kicks on then the burner will quit I can test parts on it but am not positive what the readings should be can someone help.

View more questions Search