Check out some similar questions!

earlblue · Mar 20, 2011, 09:38 AM

How do I change hold temp

mygirlsdad77 · Mar 20, 2011, 10:01 AM

Normally, you push the hold button until the hold sign on the stat appears, then just use the up and down arrows.

earlblue · Mar 20, 2011, 10:31 AM

This did not solve the problem. There are two hold temps that appears. I press hold tem and install 73 degrees. After I release, two seconds later, hold temp 66 degrees appear and stas until I press run program again.

earlblue · Mar 20, 2011, 10:38 AM

Its unfortubate that I can't get a follow up t o my question that resolve my problem. Your initial answer received in minutes. Now I can't get the service I was promised. Your site page says 100% guaranteed satisfaction. Well, I feel like I just been scammed

mygirlsdad77 · Mar 20, 2011, 10:42 AM

Hi earlblue. Really? Im a volunteer here, as are all people that try to help here. We don't get paid. And your original question (how do I change hold temp is pretty darn vague. How do you expect anyone to help with a question like that.

Im sorry I took time to play with my kids for a moment instead of waiting on the computer just to help you , so you could give me a negative rating. No more help here. Take care.

mygirlsdad77 · Mar 20, 2011, 10:54 AM

Okay, maybe Ill share just a little more. But keep in mind, its hard to say exactly if this is the case with out knowing what stat you have. etc.

On many thermostats, you press hold, set the temp, then after a few seconds, the reading goes back to what the ROOM TEMP IS. Then if you hit the up or down arrows again, it will show what you have it SET at. Then after a few seconds, it will go back to what the room temp actually is and show that instead of what it is set at. Hope this makes sense. If you happen to have the instruction booklet with the stat, it should explain all of this in there, of course, I well know that the book is usually the first thing to hit the trash. Lol. Good luck, hope I helped.