 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
how to wire a honeywell pro3000 TH3210D1004 to a goodman heat pump?
I am replacing a Janatrol T-state with a Honey well Pro 300 M/n Th3210D104 the wires from the old one were wired as such;
Wx2= white, Y= Yellow, G= green, O= orange, R= red, B= , C= blue, E= tan, (there was a non used black wire). The new T-state has the following; E, Aux, Y, G, O, L, R, B, C. I had to put the old one back on till I can get some help with this. Regards, Deb |
||||
Check out some similar questions!
Goodman heat pump, model GSH130361AD, Goodman AEPF series Air Handler, and a Honeywell T8411R t-stat. After wiring and setting everything up, the A/C works very good. In heat mode the aux heat comes on but the outside unit does not start up. Emergency heat works well too. The units are used...
I am replacing a Trane Baystat 239 thermostat with a Honeywell TH3210D1004 thermostat. The Trane thermostat is wired is follows: Terminal Color of Wire X2 Black O Orange G Green Y Yellow T Tan R ...
Installed a honeywell pro6000 stat on a carrier heat pump, cooling mode is heat pump
I am trying to install a Honeywell TH4210D thermostat to a Goodman PHKJ030-1 heat pump. Most wire colors match up but the Blue wire seems to be confusing. I'm not sure if it is a common wire on a Goodman. Also are there any jumper wires I need to install or remove?
OK even when its 17*F out I can still here it running at night. So is this a problem? I mean it runs non stop.
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
