Ask Experts Questions for FREE Help !
Ask
    fatrcat's Avatar
    fatrcat Posts: 3, Reputation: 1
    New Member
    		  
    #1

    Feb 21, 2011, 08:56 AM
    Luxaire 8T furnace flame will start then goes out
    pready's Avatar
    pready Posts: 3,197, Reputation: 207
    Ultra Member
    		  
    #2

    Feb 21, 2011, 08:59 AM

    Sounds like you have a bad sensor, as I had the same problem before.
    fatrcat's Avatar
    fatrcat Posts: 3, Reputation: 1
    New Member
    		  
    #3

    Feb 21, 2011, 09:02 AM
    How do we change sensor or does it require a technician
    fatrcat's Avatar
    fatrcat Posts: 3, Reputation: 1
    New Member
    		  
    #4

    Feb 21, 2011, 09:06 AM
    Comment on pready's post
    The sensor is it something I can replace or does it require a technician
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

My furnace will start and run for few minutes and then flame out [ 1 Answers ]

When the furnace starts it will run for a few minutes then flame out . Then I have to reset the burner

Furnace goes through normal start-up. Induced runs, Flame comes on, but no main blower [ 2 Answers ]

I have a nordyne furnace running on propane. It is about 15 months old. Furnace goes through normal start-up. Inducer fan runs, approximately 30 seconds later the flame comes on, main blower never comes on. Flame turns off. About 30 secs after flame is off, main blower comes on and stays on...

How do I start with cleaning the flame sensor on my furnace? [ 5 Answers ]

Can you tell me how to clean or replace the flame sensor? How much is it to replace?

Luxaire Furnace [ 1 Answers ]

Our furnace at our second home runs the fan but no heat comes out. This does not happen all the time. Can be a problem because we are not here all the time

Bryant Furnace won't start flame on my emergency generator [ 4 Answers ]

My newer Bryant plus 80 T gas furnace would not start the flame when it was connected to my emergency generator during an ice storm that caused the commercial power to go out. Is this a result of the poor power quality of the emergency generator which messed up the electronic circuits of the...

View more questions Search