I need a wiring schematic for a emerson 3 speed 3/4 horse power motor

Londell Posts: 1, Reputation: 1

New Member

Feb 13, 2011, 04:55 PM

I need a wiring schematic for a emerson 3 speed 3/4 horse power motor

T-Top Posts: 1,871, Reputation: 100

Ultra Member

Feb 13, 2011, 06:07 PM

The wiring diagram should be on the side of the motor. Besure to use a new run capacitor that works with the new motor you have.

Add your answer here.

Check out some similar questions!

Emerson motor condenser wiring replacing 3 wire motor with 5 wire. [ 5 Answers ]

Any recommendations? New motor apparently is capable of running in either direction by switching brown and purple wires going to the capacitor. Looks like then either the remaining brown or purple is spliced to or hooked up to the same terminal as the yellow. Thanks.

Where can I find Emerson S84A-410 Wiring schematic? [ 10 Answers ]

Hi... just had the transformer go on a Rheem RGDA-07EA-CR furnace... took the old transformer out and purchased an Emerson S84A-410 but need to get a hold of the wiring schematics to put it in... any suggestions?

Replacement emerson motor wiring different [ 2 Answers ]

I purchased a replacement fan motor for my Lennox AC unit . The old motor had 3 wires -orange , purple and black. The new one, a emerson K55HXSSm-7146 has 4 wires and a ground-black,white,brown and brown w/white. I hooked the brown wire to the dual capacitor "Fan" terminal. The Black to what...

Wiring emerson fan motor for outside unit [ 1 Answers ]

I need to how to wire a emerson motor. The old motor and a clip that you plugged in. The emerson has no clip or plug it looks like you have to hard wire it.

Emerson Motor Wiring [ 2 Answers ]

I've read (most) of the similar questions about blower motor wiring, but haven't seen any that match my configuration. I have an Emerson 1/3hp, 3spd motor with the following wires: Red, blue, black, green (ground) direct from motor. White and brown go from motor to capacitor with black out of...