Will this pulley setup work?

ricksteel Posts: 1, Reputation: 1

New Member

Feb 9, 2011, 05:48 PM

Will this pulley setup work?

Please see attached image. All assistance is highly appreciated. Thanks!

ebaines Posts: 12,131, Reputation: 1307

Expert

Feb 9, 2011, 06:09 PM

Sorry Rick- there is no image attached.

Add your answer here.

Check out some similar questions!

94 honda civic pulley bolt is welded now pulley is knocking against timing cover [ 1 Answers ]

What do I do? Its wobbly and I can't remove the bolt because it has been spot welded I need my car I'm a singly mom w/disabled child

How to take the pulley off [ 1 Answers ]

I have a troy-built lawn tractor I need to take the pulley off the shaft to take the belt out and I don't know how to get it off. It's the drive belt pulley.

Pulley questions [ 1 Answers ]

A painter of mass M stands on a platform of mass m and pulls himself up by two ropes which hang over pulleys as shown beloew. He pulls each rope with force F and accelerates upward with a uniform acceleration a. Finds-- neglecting the fact that no one could do this for long

Diagram of pulley [ 1 Answers ]

I need a diagram of the pulleys for a Yard Machine Lawn Tractor, lost my owner manuel and can not remember how belt goes on, Thank You:(

Would this setup work [ 1 Answers ]

Start with two 15amp breakers,first breaker runs to a junction box off that the wire runs to gfci outlet and then to the other outlets.now my compressor puts out 15.0/7.5amps and the light fixture is a two bulbs at 40watts.now would I be able to run light and compressor on the same breaker.I will...