Ask Experts Questions for FREE Help !
Ask
    jag437's Avatar
    jag437 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Feb 8, 2011, 12:03 PM
    How to take off mtd lawnflite pulleys?
    Can anyone help please? I have a MTD lawnflite 603/604 ride on and need to get the two belts off, how do I lock the engine up to undo the bolt holding the two pulleys on under the engine?
    Many thanks.
    Keith.
    DG's Avatar
    DG Posts: 1,375, Reputation: 109
    Ultra Member
    		  
    #2

    Feb 9, 2011, 02:26 PM

    There is a piston stop , that screws into the spark plug hole,
    However they also make a flywheel holder , to keep the motoer from turning.
    Myself I use an air gun and zip them out.
    LUCK.
    jag437's Avatar
    jag437 Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Feb 10, 2011, 10:31 AM
    Thanks DG will give it a try most helpful cheers.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Mtd lawnflite manual [ 1 Answers ]

I am looking for an owners manual for a MTD lawnflite 555. Model number 134K675c611. It was dismantled 4 years ago and I need to check belt fitting. Many thanks

Mtd lawnflite drive [ 7 Answers ]

I have a 11hp briggs and stratton powered mtd lawnflite. There is a problem with the drive to the wheels. It was progressive over last summer (where I lost drive to 5th gear, then 4th etc etc)and now I need to mower the grass it will not move when I put it into gear. Any ideas? Kind regards...

M.T.D. Lawnflite [ 1 Answers ]

I have a MTD lawnflite ride on mower, with a briggs 16 1/2 HP engine, 40 inch cut. The axle/gearbox does not engage drive as normal, but when put in to gear clonks and judders violently. I have replaced stub axle bearings as I know these can cause the chain wheel to snatch, the trouble is in the...

View more questions Search